[[TitleIndustry]]

Installation guide for LED lamp straps

Date:Sep 26, 2018

1, indoor installation: LED lamp belt for interior decoration, because do not have to withstand the wind and rain, so the installation is very simple. To light rainbow electronic production of LED lamp belt as an example, each LED lamp belt behind the affixed with self-adhesive 3M double-sided adhesive, installation can be directly ripped off the 3M double-sided adhesive surface of the sticker, and then the lamp bar fixed in the need to install the place, with the hands of the flat on the good. What if there are places that need corners or are long?

Very simple, LED light belt is a set of 3 LEDs for a group of serial and parallel circuit structure, every 3 LEDs can be cut and used alone. 2, Outdoor Installation: Outdoor installation due to the wind and rain, if the use of 3M glue fixed, a long time will cause 3 M adhesive viscosity reduction and lead to the LED lamp belt off, so outdoor installation is often used in the way of card slot fixed.

Places that need to be cut and connected, in the same way as in-room installations, simply need to be equipped with waterproof glue to consolidate the waterproof effect of the connection point. 3, Power connection method: LED lamp belt general voltage is DC 12V, so the need to use switching power supply, the size of the power supply according to the LED lamp belt power and connection length to set. If you do not want each LED light belt to be controlled with a power supply, you can buy a more powerful switching power supply to do the total power supply, and then all the LED lights with the input power supply all in parallel (the wire size is not enough can be extended separately), unified by the total switching power supply.

The advantage is that it can be centrally controlled, inconvenient place is not to achieve a single LED light band lighting effect and switch control, the specific way to use can be measured by their own. 4, controller connection: LED Happy Lantern belt and RGB full lantern belt need to use the controller to achieve the changing effect, and each controller control distance is not the same, in general, the control distance of the simple controller is 10 to 15 meters, the control distance of the remote control device is 15 to 20 meters, the maximum can be controlled to 30 meters distance.

If the LED lamp belt has a long connection distance and the controller cannot control that long light band, then a power amplifier is required for the tap. 5, pay attention to the LED lamp belt connection distance: In general, 3528 series of LED light belt, its connection distance of up to 20 meters, 5050 series of LED light belt, the maximum connection distance of 15 meters. If this connection distance is exceeded, the LED light band is easy to heat up and will affect the service life of the LED lamp belt during use.

Therefore, the installation must be in accordance with the requirements of manufacturers to install, do not let LED lights with excessive load operation.


Previous: LED Lamp Belt Maintenance instructions

Next: Features of LED lamp belt